OADM MUX/DEMUX

SKU
  • Parameter

    Value

    Channel Wavelength

    ITU Grid

    Channel Spacing

    100Ghz

    Channel Number

    4 Ch

    8 Ch

    Center wavelength Accuracy (nm)

    ±0.11

    Channel Passband (@-0.5dB bandwidth (nm)

    >0.3

    Insertion Loss (dB)

    In—Drop@drop

    2.0

    3.2

    Add---Out@add

    2.0

    3.2

    In---out@other

    2.5

    5.0

    Add/Drop Channel Ripple (dB)

    <0.3

    Isolation Channel

    Adjacent

    >25

    Non-adjacent

    >45

    Inertion Loss Temperature Sensitivity (dB/℃)

    <0.005

    Wavelength Temperature Shifting (nm/℃)

    <0.002

    Polarization Dependent Loss (dB)

    <0.1

    Polarization Mode Dispersion (ps)

    <0.1

    Directivity (dB) (Input to add, Output to drop,

    >50

    Return Loss (dB)

    >45

    Maximum Power Handling (mW)

    500

    Size

    OTU Module

    26.5(W)x252(D)x195(H)(mm)

    1-slot chassis

    482.6(W)x350(D)x43.6(H)(mm)

    8-slot chassis

    482.6(W)x360(D)x109(H)(mm)

    16-slot chassis

    482.6(W)x360(D)x261.6(H)(mm)

    Opterating Temperature (℃)

    -5~+75

    Storage Temperature (℃)

    -40~85

  • Extending the capabilities of Wave Division Multiplexing systems, STC8000 DWDM Passive OADM modules from Swedish Telecom OPTP can add or drop up to eight wavelengths at specific locations along a DWDM trunk. The technology enables intelligent planning and flexible provisioning of optical services while simplifying the deployment and maintenance of optical networks.

    DWDM passive OADM modules are protocol-transparent, so their operation is invisible to both the network and the users. With plug-n-play setup and a design that minimizes budget loss, it can readily and seamlessly integrate into an existing network. The small form factor and power independence allow the module to deploy virtually anywhere.

    DWDM passive OADM modules are available in single-sided (East or West) and dual-sided (East and West) configurations The STC8000 Passive OADM modules are available with 2, 4, 8 independent wavelengths. Each single-slot high-density module installs in any Swedish Telecom OPTO chassis. A powered chassis is required only for managed applications.

    • Optical Add/Drop Multiplexing (OADM)
    • Passive OADM-4 , 8, 16 channels
    • DWDM C-Band, 100GHz ITU Grid (0.8nm spacing)
    • Single-side (east or west) or dual-side (east and west)
    • Versatile topology support
    • Point-to-point bus
    • Linear point-to-multipoint
    • Low insertion losses
    • Power required only for managed applications
    • 1-slot design with hot-swap support fi ts any ST8000 chassis
    • Low insertion loss
    • Power required only for managed applications and LEDs
    • STC8000 1-8-16 slot chassis compatibility

Quality Certification

Please Note: Installing a third party transceiver does not void your network equipment warranty.

You recently viewed

Clear recently viewed